FEC AFC1100 User Manual
Page 2
)(& ,QF
4.1
Design and Build Procedure
Review Chapters 1 and 2 prior to designing a System. If the requirements and
specifications in these two (2) Chapters are not addressed, there is a chance of degraded
System performance.
WARNING:
Follow Lockout/Tagout and other safety precautions when connecting and/or
disconnecting cabling, wiring, and equipment.
5.2
Confirm normal operation.
Verify normal function.
16
Chapter 6
Chapter 7
Set the preset data for torque, angle, speed, time,
etc.
Input preset data.
15
5.1
VERIFY WIRING AND THE VOLTAGE OF ALL
POWER SUPPLIES PRIOR TO POWERING UP.
Turn on the equipment.
14
Appendix A
VERIFY POWER IS OFF, then connect cables for
every motor, encoder and preamplifier.
Connect homerun cables.
13
4.7
Connect all PLC wiring. VERIFY VOLTAGE
SOURCE PRIOR TO CONNECTION.
Wire PLC connections.
12
4.6
Connect the power cables. VERIFY VOLTAGE
PRIOR TO APPLYING POWER.
Wire power connections.
11
4.2
4.3
Refer to recommended installation layout.
Mount the Axis Units in the
enclosure.
10
4.10
Check the setting before connecting the Unit.
Set Axis Unit dip switches.
9
4.2
4.3
Keep clearances among units according to the
recommended installation layout.
Select NEMA 12
enclosure.
8
4.7
Select a PLC which will facilitate direct connection
to the AFC1100 System I/O (24 VDC true low).
Select an adequate PLC.
7
4.7
A PLC logic program can be written using signal
descriptions and timing charts provided.
Design (or review) PLC
logic.
6
2.1
Select an air handling unit applicable to the
environmental conditions (A/C, Heat Exch., etc.)
Select an air handling unit
(as required).
5
4.6
4.7
Circuit protection for Axis Units should be separate
from other units.
Select the circuit
protectors.
4
2.5.1
Different tool motors require different Servo
Amplifiers. Ensure the correct one is selected.
Select correct Axis Unit for
the tool selected.
3
4.4
4.4.3
Design of mounting plate / powerhead requires
adherence to several specifications.
Design tool mounting plate
/ powerhead / spindle
assemblies.
2
2.5.1
4.4.1
4.4.2
Keep torque range between 50% and 75 % of tool
capability for best performance.
Ensure fastening bolt pattern and tool mounting
patterns are compatible.
Select correct tool size.
1
Reference
Section
Comments
Items
No.
Chapter 4: System Setup and Wiring (Rev. 8/98)
Page 4-2