Fairbanks 6020 Series Titan Motor Truck Scale - Manual (Page 10)

OPTION 1:
Set the module directly on the locating tools and the blocks will act as safety stands.
• Install a load cell bearing cup with "O" rings into the upper receiver of each corner
on the module. Grease will help hold the cup in place.
• Insert the upper end of the locating tool into the upper cup on the module.
• Lower the module while holding the locating tool upright and guiding the bottom of
the tool into the lower cup.
• When the base module is set on all four locating tools, keep tension on the cables
until the module is centered and straight.
• Use hydraulic jacks to lift the unit slightly and shift the base plates to get the locating
tools plumb and the top and bottom flanges flush with the sides of the cup.
OPTION 2:
Set the modules on the blocks first, then on to locating tools.
• The module is set on the blocks, keep tension on the cables until the module is
properly aligned.
• Use hydraulic jacks to lift the unit slightly, then install the locating tools. Shift the
base plates to get the tools plumb and the top and bottom flanges flush with the
sides of the cup.
e. Measure from each side of each end of the module, to the end walls, to be
certain the module is plumb and square before removing tension.
f. Once the tension on the lift cables is released, remove the lift brackets and/or
hooks.
3. Setting End Modules
• Module Placement - Guide the modules into place with the supporting blocks on
the end of the module coming to rest on the supporting blocks of the center
module. Lower the other end of the module onto the load cell locating tools or
blocks.
50745 10 03/10 Rev. 5
50745-3