Fairbanks 6020 Series Titan Motor Truck Scale - Manual (Page 8)

B. Foundation:
Before installing any part of the scale, the foundation must be checked for accuracy
using Foundation Inspection, Field Check List, FF-2267 / 101732 (see Appendix ).
1. Layout and position the base plates in the proper locations using the Methods &
Procedures and certified prints. Each base plate must be level and in full contact
with the top of the pier. Adjustments can be made by chipping the concrete or
grouting under the base plates.
2. Re-check the locations of each base plate against the certified prints. Insert two ½ "
roll pins into each base plate for anti-rotation. Position the plates with pins towards
the outside. This will leave the load cell cable exiting the load cell to the inside. It is
not necessary to install base plate anchors at this time.
3. Grease and install the inner O-ring in each load cell receiver cup. On all load cell
receiver cups, grease the large outer O-rings, then install one in the groove on the
outside of each cup. Put a 1/8" shim on the lower cups, grease the outside, then
insert the shim(s) into the base plates. Lower cups for the load cells have a pin
which must be aligned between the two roll pins in the base plate.
4. Place the upper cup with greased O-ring on the edge of the the upper foundation
next to each base plate.
5. Place the load cell locating tool next to each base plate.
50745 8 03/10 Rev. 5
UPPER L.C. RECEIVER CU UPPER L.C. RECEIVER CUP P
P PA ART RT #87482 #87482
P PA ART RT 87481 87481
LOWER L.C. LOWER L.C.
RECEIVER CU
RECEIVER CUP P
FOR INITIA FOR INITIAL L iNS iNST TALL ALLA ATION TION
USE (1) 1/8" SHIM USE (1) 1/8" SHIM
6" LOAD CE 6" LOAD CEL LL L
P PA ART RT #80453 #80453
"O"-RING ON EACH RECEIVER CU "O"-RING ON EACH RECEIVER CUP P
BASE BASE P PL LA ATE TE
LOAD CEL LOAD CELL L ASSEMB ASSEMBL LY Y DE DET TAI AIL L
LOAD CE LOAD CEL LL L CABLE HANGER CABLE HANGER
(INSIDE (INSIDE F FACE OF SCALE) ACE OF SCALE)
PART #
PRE-TAPPED BAR
FOR JUNCTION BOX
CABLE HOLES
50745-1