Fairbanks 6020 Series Titan Motor Truck Scale - Manual (Page 11)

4. Before releasing cable tension
• Check the alignment of the end modules to the center or base module and to
the end wall.
• Using the provided shims, fill any gaps on the supporting blocks and get the
modules properly aligned.
5. Connecting the Modules:
• Bolt the modules together using the 1 1 /
8
" x 8" threaded rod, lock washers, flat
washers and nuts provided. Tighten the bolts snugly, but do not tighten them
completely. Shim the supporting blocks, if necessary, to align the modules.
6. Checking Adjustment
a. Adjust End Checking
• Adjust the End Checking Bolts until they touch and prevent movement.
b. Install the side checking brackets:
• Bolt the brackets to the end checking plates embedded in the end walls per
certified prints. Adjust the bolts until they touch the channels they bump against.
50745 11 03/10 Rev. 5
PANEL CONNECTION DETAIL
50745-4
* * Warning * *
Module-to-module bolts MUST be installed correctly and torqued properly after all lifting is
completed. Do Not substitute or omit bolts.