Fairbanks 6020 Series Titan Motor Truck Scale - Manual (Page 20)

A. Field Installed Rub Rail Installation
• Disconnect all loadcells. Electrically isolate the load cells from the platform.
• Use the print with the accessory for actual measurements
• Clean (remove primer) the areas to be welded for good penetration.
• Weld stiffeners to the side weldments.
• Bolt the gussets to the stiffeners and end weldments.
• Weld pipe to the gussets.
• Clean and paint (paint provided) all weld areas.
50745 20 03/10 Rev. 5
Section 7: Accessories
* * Warning * *
Fairbanks does NOT recommend using foundation- or ground-installed guide rails along
the sides of a truck scale platform. Damage may occur to the scale if a truck hits the
guide rail, transferring damaging forces to the platform and the checking system.
Use of this style guide rail will void product warranty.
PIPE
1/4"
TYP.
GUSSET
1/2"
UP WELD WELD
TYP. VERTICAL
NO WELD
2 3/8"
NO WELD
2 3/8"
STIFFENERS
GUSSET 3" DIA. PIPE
50745-2