Fairbanks HVX Series TALON SERIES Motor Truck Scale User Manual
Page 11
A. Introduction
Installation consists of the following:
•
Foundation check, layout, and base plate setting
•
Tools, materials, documentation, and a crane
•
Setting the modules
•
Setting the modules on load cells
B. Preparations for Installations, all Models
1.
Tools, Equipment, and Materials Required:
a. Certified Prints
b. A mobile crane of sufficient capacity to safely lift and place the weigh bridge
modules.
Approximate maximum weights:
•
Steel modules
-
4 tons
•
Field pour Modules -
2.5 tons
w/concrete
-
12.5 tons to 15 tons +/- 5%
c.
Four (4) equal length (20 ft) lifting chains or cables with hooks to safely attach
to the modules at the lifting points.
d.
Machinists levels (starrett # 134 & 132-6)
e.
Hand tools
f.
Hammer Drill with
5
/
8
" bit, 24" long
50785
11
04/12 Rev. 5
Section 2: Installation
Note: The lifting chains or cables MUST be requested in advance from the crane vendor.
Note: Additional installation instructions are provided for the Field-Pour deck in Section 3
of this manual.