Fairbanks HVX Series TALON SERIES Motor Truck Scale - Manual (Page 19)

50785 19 04/12 Rev. 5
• Bulkheads: In the middle of the module or bridges are bulkheads. These
bulkheads are part of the bridge’s orthotropic design. Cables may be run over
them to keep the cables off the ground. Run the interconnecting cable between
the top of the bulkhead and the bottom of the deck plate (see Figure 50785-3).
• Complete installation: Once all cables have been run and wiring is complete
(see Section 4), tighten all the cables and hang them on the cable hangers to
get them out of sight and off the ground. In a correct installation, the only
cables visible are those coming out of the holes in the side beam to the SSC or
PPS. See below.
10. Final Checking Adjustment:
a. Adjust End Checking
•
Adjust the End Checking Bolts to allow 1 / 16 ” to 1 / 8 ” clearance.
b. Adjust side checking bolts to allow 1 / 16 ” clearance from Bumper Block.
50785-3