Acer Altos G320 Series - Manual (Page 112)

Appendix B: SATA RAID configuration 102
RAID configuration utility
The RAID CU configures disk arrays and logical drives. The CU resides in
the BIOS and is independent of the OS. With the CU you can:
• Configure physical arrays and logical drives
• Initialize logical drives
• Rebuild failed drives
• Check data consistency
Using the RAID configuration utility
Starting RAID CU
1 Before attempting to use the RAID configuration utility, make sure
you set the Configure SATA as parameter in the BIOS setup to
RAID.
To set the SATA channels as RAID, do the following:
(1) During bootup, press F2 to enter the BIOS setup screen.
(2) Select the Advanced menu, then press Enter.
(3) In the Advanced menu, select Drive Configuration, then
press Enter. The following window appears.
AA G320_UG_EN.book Page 102 Tuesday, August 30, 2005 2:34 PM