Acer Altos G320 Series - Manual (Page 129)

119
Using the MegaRAID configuration utility
Turn on the system. When prompted, press Ctrl+M to enter the
MegaRAID configuration utility. After a few seconds, the Management
menu appears.
Loading the RAID card default setting
1 In the Management menu, select Objects, then select Adapter.
The current adapter settings appear.
2 Select Factory Default, then Yes to load the default settings.
3 Press Ctrl+Alt+Del to reboot the server.
Creating a RAID 1 volume
1 After rebooting the server, press Ctrl+M to enter the MegaRAID
Configuration screen. The Management menu appears.
2 Select Configuration. The Configuration menu appears.
3 Select New Configuration, then select YES. An array selection
window displays the devices connected to the current controller.
4 Use the arrow keys to select a specific drive, then press the
spacebar to associate the selected drive with the current array.
In the menu, the selected drive’s indicator will change from READY
to ONLINE A[array number]-[drive number].
For example ONLINE A1-2 means disk drive 2 in array 1.
5 Add two drives to the current array, then press Enter.
6 Press F10 to configure the logical drives. The default RAID level for
2 disk drives is RAID 1.
7 Select Accept to use the default setting, then press Enter.
8 Press Enter again to end the array configuration.
9 Select YES to Save Configuration, and press any key to return to
the Configuration menu.
Assigning a hot spare disk
1 In the Configuration menu, select Add/View Configuration.
2 Use the arrow keys to select a specific drive, then press F4 to set
the drive as a hot spare disk.
AA G320_UG_EN.book Page 119 Tuesday, August 30, 2005 2:34 PM