Acer Altos G320 Series - Manual (Page 124)

Appendix B: SATA RAID configuration 114
One of the hard drives in
a mirrored (RAID 1) array
has failed. Replace the failed drive with another drive that
has the same or greater capacity.
A new drive with no
configuration is installed
into the bay which is
already part of a
mirrored (RAID 1) array. Run the RAID configuration utility to configure
the new drive. Mark the drive as one of the
following:
• Failed - If the AutoRebuild option is disabled
in the CU.
• Rebuilding - If the AutoRebuild option is
enabled in the CU.
A new drive with no
configuration is installed
into the bay which is
already part or not part
(is by itself) of a striped
(RAID 0) array. Run the RAID configuration utility to configure
the new drive.
Problem Suggested solution
AA G320_UG_EN.book Page 114 Tuesday, August 30, 2005 2:34 PM