Acer Altos G320 Series - Manual (Page 121)

111
Rebuilding failed disks
A manual rebuild is used to rebuild failed drives. The CU allows manual
rebuild for an individual drive or a group of drives. The rebuilding of a
group of drives is done through batch mode.
To rebuild a group of failed drives:
1 In the Management menu, select Rebuild.
A device selection window displays. In the window the failed
drives’ indicators will display FAIL.
2 Use the arrow keys to select the drives to be rebuilt, then press the
spacebar to select the highlighted drives for rebuild.
3 Press F10, then select Yes at the confirmation prompt.
The selected drives’ indicators will change to REBLD.
4 After the rebuild is completed, press Esc to return to the
Management menu.
To rebuild an individual drive:
1 In the Management menu, select Objects, then Physical Drive.
2 Use the arrow keys to select a specific drive, then press Enter.
3 Select the Rebuild option from the menu, then respond to the
confirmation prompt.
4 After the rebuild is completed, press any key to display the
previous menu.
Note: If you have auto-rebuild enabled in the BIOS, the rebuild
begins as soon as you enter the BIOS CU. If auto-rebuild is
disabled, you have the option to rebuild by following the
procedure in above section.
AA G320_UG_EN.book Page 111 Tuesday, August 30, 2005 2:34 PM