Configuring the scsi/scsi raid hba, Using the scsi hba setup utility, Loading the hba default settings – Acer Altos G320 Series User Manual
Page 127: Creating a raid 1 volume with a hot spare disk
117
Configuring the SCSI/SCSI RAID HBA
This section shows how to create a RAID 1 (mirror) volume. This feature
requires the installation or presence of a LSI Logic 53C1030 SCSI
controller.
Using the SCSI HBA setup utility
During bootup, press Ctrl+C to enter the LSI Logic Configuration
screen.
Loading the HBA default settings
1
In the LSI Logic MPT SCSI setup screen, press F2.
2
Select Global Properties, then select Restore Defaults.
3
Press Esc, then select Save changes then exit this menu.
4
Select 53C1020/53C1030, then press Enter.
5
Select Restore Defaults, then press Enter.
6
Press Esc, then select Save changes then exit this menu.
Creating a RAID 1 volume with a hot spare disk
1
In the LSI Logic MPT SCSI setup screen, select 53C1020/53C1030,
then press Enter.
2
Select RAID Properties, then press Enter.
3
In the Array Disk field, press the spacebar.
If you change the settings in the Array Disk field, the following
messages appear:
F3 - Keep Data (Create 2 disk arrays)
Delete - Erase Disk (Create 2 to 6 disk arrays)
4
Press the Delete key to erase all data on the screen.
5
In the Hot Spare field, press the spacebar.
If you change the settings in the Hot Spare field, the following
messages appear:
AA G320_UG_EN.book Page 117 Tuesday, August 30, 2005 2:34 PM