IAI America RCA2-TW4N - Manual (Page 16)

8
Handling Precautions
1. Do Not Set Speed and Acceleration/Deceleration Higher
Do not set speed and acceleration/deceleration higher than the rated values. It causes vibration, failure, or
shortening of life. If acceleration/deceleration higher than the rated value is set, creeping phenomenon or
coupling slide may occur.
2. The Allowable Load Moment Must be Within the Tolerance.
The allowable load moment must be within the tolerance value. If a load exceeding the allowable load
moment is applied, the life may be shortened. If an extreme load is applied, flaking may occur.
3. Oil Film of Grease May Run Out If Short-distance
Reciprocating Operation is Performed.
When performing continuous reciprocating operation of a distance of 30 mm or shorter, oil film of grease
may run out. To recover oil film, perform approximately five cycles of a distance of 50 mm or longer, every
5,000 to 10,000 cycles, as a guideline
4. Handling of Spiral Cover
The spiral covers used on short types (TC3N, TC4N, TW3N, TW4N, TF3N, TF4N) are each made of a thin
sheet rolled into a spiral form. Exercise caution not to bump the spiral sheet or press it strongly with fingers,
because the spiral sheet may deform.
5. Make sure to attach the actuator properly by following this
Using the product with the actuator not being certainly retained or affixed may cause abnormal noise, vibration,
malfunction or shorten the product life.
Spiral cover
operation manual.
Than the Rated Values.