3 installation of the load – IAI America RCA2-TW4N User Manual
Page 83
75
9. Installation
9.3
Installation of the Load
9.3.1
Motor unit types TA4*, TA5*, TA6*, TA7*
Please attach the load to the device using the tapped holes in the front plate of the table type.
There are also tapped holes and reamed holes in the top surface of the table. Please use these to
attach the load.
There are two reamed holes on the slider in the top surface of the table, so if you need to be able to
secure and detach the load multiple times, please use these holes. Also, if you require precision in
your attachment, such as a right angle, use one of the reamed holes to make fine adjustments.
The process for attaching these to the main unit is similar to the installation process of the main unit.
The mounting screws and tightening torque required are also similar to the installation process of the
main unit. (Refer to 9.1.1.)
For exact screw-in depth, please see the table below.
Do not screw in screws deeper than indicated in the table below, as this can interfere with internal
parts and damage the actuator.
Model
A
B
C
D
TA4*
29
5
13
M6, depth 10
TA5*
29
6.5
14
M6, depth 10
TA6*
35
7
18
M6, depth 13
TA7*
44
6.5
21.5
M8, depth 15
A
3-D
B
C