IAI America RCA2-TW4N - Manual (Page 70)

62
8. Installation Environment and Storage Environment
8. Installation Environment and Storage Environment
8.1 Installation Environment
Install the actuator in an environment meeting the following conditions:
Not exposed to direct sunlight
The machine does not receive radiated heat from large heat sources such as heat treatment furnaces.
Surrounding air temperature of 0 to 40°C
Humidity of 85% or below, non-condensing
Not subject to corrosive or flammable gases
Is a normal environment for assembly work where there is not much dust.
Not subject to oil mist or cutting fluid
Not subject to impact or vibration
Not subject to significant electromagnetic waves, ultraviolet light or radiation
This product is not designed to provide chemical resistance.
In general, the environment shall be one where the operator can work without wearing protective gears.
Open space required for maintenance inspection
8.2 Storage Environment
The storage environment should conform to the installation environment. Particularly when the actuator is
stored for a long period of time, give consideration to prevent bedewing.
Unless specified, the actuator is shipped without any drying agent placed in the package. If the actuator is
stored in an environment subject to bedewing, implement anti-bedewing measures over the entire
package or directly on the actuator after unpacking.
The maximum storage temperature is 60°C for a short period. If the storage period exceeds 1 month,
make sure the storage temperature dose not exceed 50°C.
250mm