Connection with controller – IAI America RCA2-TW4N User Manual
Page 91
83
10. Connection with Controller
10. Connection with Controller
For the controller and the connection cable between the controller and RCA2 (this actuator), use IAI’s
dedicated controller and dedicated connection cable.
The following explains the wiring method based on single-axis use.
In applications where the dedicated connection cable cannot be secured, make sure the cable does
not deflect more than it would due to the dead weight, or use a self-supporting cable hose or increase
the cable radius to minimize the load applied to the dedicated connection cable.
Do not cut and extend, shorten or reconnect the dedicated connection cable.
Do not pull or forcibly bend the dedicated connection cable.
If you wish to change the specification of the dedicated connection cable, consult IAI.
Dedicated connection cable
Servo motor cable : CB-APSEP-MPA***
*) *** indicates the cable length. Up to 10 m can be specified.
Example) 080 = 8 m
IAI’s dedicated connection cable
(Connects the RCA2 and dedicated controller)
Dedicated controller
ASEP
r = 68 mm or more (movable)
r = 34 mm or more (fixed)