IAI America LSA-L15SS - Manual (Page 35)

2. Installation
29
2. Installation
2.1 Transportation
Warning: This actuator uses high-performance rare-earth permanent magnets. Therefore,
those who are wearing a pacemaker or any other medical device must not come
within 30cm of the actuator.
[1] Handling of the Actuator
Unless otherwise specified, the actuator is shipped with 1 axis unit packaged separately.
(1) Handling the Packed Unit
y Do not damage or drop. The package is not applied with any special treatment that enables it
to resist an impact caused by a drop or crash.
y Transport a heavy package with at least more than two operators. Consider an appropriate
method for transportation.
y Keep the unit in a horizontal orientation when placing it on the ground or transporting. Follow
the instruction if there is any for the packaging condition.
y Do not step or sit on the package.
y Do not put any load that may cause a deformation or breakage of the package.
(2) Handling the Actuator After Unpacking
y Do not carry the actuator by its motor unit or its cable or attempt to move it by pulling the
cable.
y Hold the base part or bracket part of the body when transporting the actuator main body.
y Do not hit or drop the actuator during transportation.
y Do not attempt to force any part of the actuator. Do not apply force especially on the stainless
steel sheet.
[Taboos in transportation]
Do not transport the actuator by holding its slider. Do not transport the actuator by holding its cables.
Do not transport the actuator by holding its cable track. Do not transport the actuator by holding its
stainless steel sheet.