IAI America XSEL-S - Manual (Page 22)

Chapter 1 Installation and W
iring
14
1.2 Confirmation of Products
1.2.1 Configuration
The electronic CAM is configured in the following two patterns.
[1] Configuring using both X-SEL and RC controller or RC controller only
X-SEL
Connecter terminal block conversion unit
The customer shall provide the unit.
(Note) Normal terminal blocks can be
used.(ex. OMRON – Model:XW2D-
50G6)
Connector terminal block conversion unit
The customer shall provide the unit.
(Note) The connector can be disconnected
and normal terminal blocks can be
used. (ex. OMRON – Model:XW2D-
50G6)
RC controller
Pulse I/O cable
CB-X-PQ-PLIOS H6
PIO board
Extension motion
control board
I/O flat cable
x CB-X-PIO 50P I/O cable
x CB-X-PIO H6 I/O cable, with
connectors on both sides
x CB-X-PIOH 100P I/O cable