JuiceGoose P90 Series - Manual (Page 21)

P90 USER’S MANUAL UNINTERRUPTIBLE POWER SUPPLY (UPS)
Xtreme Power Conversion Corporation (Rev 8/29/13) Page 21
Step 3
UPS Input Connection
Connect the UPS to an approved electrical input source consistent with the input power cord connection
provided with the UPS. Do not replace the power cord or use a substitute. Avoid using extension cords
when connecting AC input to any UPS.
UPS Output
There are two types of output on the P90-1000, P90-1500, and P90-2000 models - programmable
outlets and general outlets. Please connect non-critical devices to the programmable outlets and critical
devices to the general outlets. During power failure, you may extend the backup time to critical devices
by setting shorter backup time for non-critical devices.
Programmable outlets can also be used to re-cycle the power to remote devices if required to re-start a
server due to lock-up issues.
Starting the UPS
Press the ON/MUTE button on the front panel of the UPS for two seconds to power on the UPS.
Note: the battery charges during the first five hours of normal operation. Do not expect full battery run
time during the initial charge period.
Your UPS is now mounted
as shown in the tower
position