Diagnostic tests, System configuration – JuiceGoose P90 Series User Manual

Page 8

Advertising
background image

P90 USER’S MANUAL

UNINTERRUPTIBLE POWER SUPPLY (UPS)

Xtreme Power Conversion Corporation (Rev 8/29/13)

Page 8

Block Diagram

Diagnostic Tests

When the UPS is started, a diagnostic test is automatically executed, checking the electronics and
batteries, reporting any problems on the LCD display.

SYSTEM CONFIGURATION

The UPS device and the internal batteries make up the system. Depending on the site and load
requirements of the installation, certain additional options are available for the solution.

Planning a UPS system, the following should be taken into consideration:

• The total demand of the protected system shall dictate the output power rating (VA). Allow a

margin for future expansion or calculation inaccuracies from measured power requirements.

• Backup time required will indicate the battery size needed. If the load is less than the UPS

nominal power rating, then actual backup time is longer.

• The following options are available:

o

Connectivity Options –SNMP/WEB card

See the Specification section of this manual for additional model information.

Advertising