KB Electronics KBIC-240DS - Manual (Page 3)

3
1 QUICK-START INSTRUCTIONS
Important: You must read these simplified instructions before proceeding. These instructions are to be
used as a reference only and are not intended to replace the details provided herein. You must read the
Safety Warning on, page 5, before proceeding.
See Figure 1, on page 4. Also see Section 3 - Application Information, on pages 6 and 7.
WARNING! Disconnect main power before making connections to the speed control.
1.1 Be sure the AC input line voltage corresponds to the control voltage. See Table 2, on page 8.
1.2 Install the correct Plug-In Horsepower Resistor ® according to armature voltage and motor
horsepower. See Table 6, on page 11.
1.3 Recheck connections: AC line to L1 and L2, armature to A+ and A- and Field (Shunt motors only)
to F+ and F-. (Note: If motor runs in improper direction, interchange armature leads with Main
Power disconnected.) See Figure 1, on page 4.
1.4 It is recommended that both AC line and armature fuses be installed. See Table 4, on page 9.