KB Electronics KBIC-240DS - Manual (Page 5)

5
2 SAFETY WARNING
Definition of Safety Warning Symbols
Electrical Hazard Warning Symbol: Failure to observe this warning could result in electrical shock
or electrocution.
Operational Hazard Warning Symbol: Failure to observe this warning could result in serious injury or
death.
This product should be installed and serviced by a qualified technician, electrician, or electrical
maintenance person familiar with its operation and the hazards involved. Proper installation, which
includes electrical connections, fusing or other current protection, and grounding, can reduce the chance of
electrical shocks, and/or fires, in this product or products used with this product, such as electric motors,
switches, coils, solenoids, and/or relays. Do not use this drive in an explosion-proof application. Eye
protection must be worn and insulated adjustment tools must be used when working with drive under
power. This product is constructed of materials (plastics, metals, carbon, silicon, etc.) which may be a
potential hazard. Proper shielding, grounding, and filtering of this product can reduce the emission of radio
frequency interference (RFI) which may adversely affect sensitive electronic equipment. It is the
responsibility of the equipment manufacturer and individual installer to supply this Safety Warning to the
ultimate end user of this product. (SW 1/2006)
This drive contains electronic Start/Stop circuits, which can be used to start and stop the drive. However,
these circuits are never to be used as safety disconnects since they are not fail-safe. Use only the AC line
for this purpose.
Be sure to read and follow all instructions carefully. Fire and/or electrocution can result due to improper
use of this product.
This product complies with all CE directives pertinent at the time of manufacture. Contact the Sales
Department for Declaration of Conformity. Installation of a CE approved RFI filter is required (see Table 7,
on page 24). Additional shielded cable and/or AC line cables may be required along with a signal isolator
(SI-5 (Part No. 9443)).