LEESON Chassis Mount PWM Control: M1740009.00 - Manual (Page 13)

7 Installation
Quick-connect terminal block
The quick-connect terminal block has an 8-pin header block
and 8-screw terminal plug (Figure 4). To use the quick-
connect terminal block:
1. Carefully pull the terminal plug from the header block.
2. With a small flat-head screwdriver, turn the terminal plug
screw counterclockwise to open the wire clamp.
3. Insert a stripped wire into the large opening in front of
the plug.
4. Turn the terminal plug screw clockwise to clamp the
wire.
5. Repeat steps 2 through 4 for each terminal until all
connections are made.
6. Insert the plug into the header until securely fastened.
HEADER
BLOCK
TERMINAL
PLUG
Figure 4. Quick-Connect Terminal Block