Staub Electronics B-500-MTRX-230-8X16 BINARY - HDMI 8X16 MATRIX SWITCH WITH HDMI AND HDBASET OUTPUTS - Manual (Page 10)

B-500-MTRX-230 Installation Manual
Pg. 10
© 2013 Binary ™
7.4. Switcher Location and Placement
Binary matrix switchers are designed to deliver unsurpassed technology with superior performance. However, where
you install the switcher can have a large effect on the performance that you receive, and the life of the unit. Here are
some guidelines to follow when installing a B-500-MTRX-230 Switcher.
• Be sure that the unit is in a well-ventilated area that provides adequate cooling.
• Do not block the cooling vents located on both sides of the unit.
• Do not place the unit on carpeting or any similar material.
• Do not install the unit near a source of heat, or in an extremely humid or wet location.
• If your installation lacks good air flow (such as solid cabinet doors or wall-mounted racks), it may be necessary to
create ventilation to allow outside air into the space.
• Allow a minimum of 3” of free air space on either side of the unit. (Does not apply to rack mounting)
• Allow a minimum of 2” of depth behind unit to accommodate cables and connectors.
• When placing on a cabinet shelf, position the unit with all feet resting on a solid level surface.
7.4.1. Rack Installation
The B-500-MTRX-230-8X16/16X16 can be mounted in a rack with the front or rear panel facing outward, and will
displace 3U of vertical space when installed. Rear-facing installation allows for easy access to the connections
for installations that do not require the front panel of the unit to be accessed. Front-facing mounting is useful for
applications where the front panel must be accessible or visible.
The rack ears are packaged separately from the matrix switcher in the box. Attach the ears to the sides of the matrix
at the front or back using the included screws. Tighten them with a #2 Phillips Screwdriver. It may be necessary to
remove the feet from the bottom when rack mounting the matrix switcher. Remove the screws for the feet with a #2
Phillips Screwdriver, and store the feet and screws together in case they are needed in the future.
Note: The rack ears and mounting holes are only designed to safely hold the weight of the B-500-MTRX-230.
Do not use the matrix switcher as a shelf for other equipment in the rack.