Staub Electronics B-500-MTRX-230-8X16 BINARY - HDMI 8X16 MATRIX SWITCH WITH HDMI AND HDBASET OUTPUTS User Manual
Page 17
B-500-MTRX-230 Installation Manual
Pg. 17
www.snapav.com Support: 866.838.5052
7.10.2. IR Pass-Through from Rooms to Sources
The diagram above illustrates a typical installation with a B-500-MTRX-230 where all of the equipment is being
controlled by IR remotes in each output zone.
• In each room with a connected display, an entry-level universal IR remote is being used to control the display
and sources in use. Custom programming set up in each remote by the installer sends IR commands out of the
remote meant for the display device in the room, the sources, and the matrix switcher simultaneously. The matrix
commands are programmed to be sent automatically as needed so the end user only has to select the source they
want to watch.
• To make this system work seamlessly, two advanced IR options have been enabled in the matrix switcher
Configuration Utility “Other Settings” menu: IR Source Routing and IR Matrix Control from room.
ᵒ IR Source Routing allows the commands from the room to be routed directly to the source selected to be
displayed in the room. This simplifies IR routing because only one flasher has to connect to the source.
ᵒ IR Matrix Control sets the matrix switcher so that any command sent from any HDBaseT output to control
the matrix is automatically received internally, eliminating the need for an external connection back to the
matrix for control.
See Section 9. Advanced Setup Using the Configuration Utility on page 22 for more information on
changing these settings.
• When the commands are sent, the display device is controlled directly by the remote. The commands for the
matrix switcher and sources are picked up by the IR receiver connected to the B-500-RX-230-IR and sent back to
the correct IR OUTPUT TO SOURCE port and to the matrix.
• When the system is in use, if two outputs are connected to the same input, the source will change on both outputs
with any command sent since it can’t send two HDMI streams at once. This must be considered when deciding on
the sources to connect for distribution.
Example: In a home with five displays connected, if users in every room want to watch satellite on
different channels, there must be five satellite receivers set up as sources. With custom programming,
each output can be programmed to use only one of the satellite source inputs, giving each output a
dedicated satellite box while allowing other less-used sources to connect to any output.
12V DC 11.2A
INPUT
IR INPUT
TO ROOM
IR INPUT
TO ROOM
IR OUTPUT
TO SOURCE
IR OUTPUT
TO SOURCE
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
O
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
UTPUTS
12V DC 11.2A
INPUT
LINK
LINK
LINK
LINK
LINK
LINK
LINK
LINK
LINK
LINK
LINK
LINK
LINK
LINK
LINK
LINK
O
N
B-500-RX-230-IR
PLAY
HDMI Source
256
HDMI Source
IR Flasher
IR Flasher
HDMI
HDMI
HDTV
IR Receiver
IR Receiver
B-500-RX-230-IR
HDMI
IR Receiver
HDMI
IR Receiver
Cat5e/6
Cat5e/6
Projector