Staub Electronics B-500-MTRX-230-8X16 BINARY - HDMI 8X16 MATRIX SWITCH WITH HDMI AND HDBASET OUTPUTS - Manual (Page 23)

B-500-MTRX-230 Installation Manual
Pg. 23
www.snapav.com Support: 866.838.5052
11. Operation and Control
During setup and testing, use the included IR remote to control the matrix switcher. After setup is complete, a control
method should have been setup and programmed as described in Section 7.7. Matrix Control Connections for regular
operation.
11.1. IR Remote
11.1.1. Route Inputs to Outputs
This section describes the correct button-push sequences to perform regular operations with the IR remote.
To enter a number higher than 9 when selecting an input or output, press the “10+” button to enter 10, or press
“10+” followed by the desired number for 11-16 (Example: “10+” + “2” = 12).
POWER
1
ON OFF
2 3 OUTPUT
INPUT
OUTPUT
OFF
STATUS LEARN DEFAULT CLEAR
ALL
4 5 6
7 8
10+ ENTER
9
1 2
3
4 5 6
7
8
9
10 11 12 13
Key Function
1 ON Power on the matrix switcher
2 OFF Enter standby mode
3
Number Keys
1-9
Select a number
4 10+ Select numbers for Input or Output higher than 9
5 ALL Select all Inputs or Outputs
6 ENTER* Enter to trigger the previous setting
7 OUTPUT Kick off output selection
8 INPUT Kick off input selection
9 OUTPUT OFF Turn off/Mute the selected Output
10 STATUS Present EDID or Output status
11 LEARN Learn EDID from one output
12 Default Kick Off Embedded EDID Selection
13 CLEAR*
Clear the former IR operation procedure which user
just pressed but has not yet applied by pressing
ENTER
Input to Single Output
Example: Output=3 Input=4
Display Readout (Example)
1. Press OUTPUT  
2. Press Number Key/s to select the Output the EDID is learned
from. Use 10+ to select Outputs through 10-16
0 
3. Press INPUT 0
4. Press Number Key/s to select the Input. Use 10+ to select Inputs
through 10-16
0 04
5. Press ENTER 0 04