Staub Electronics B-500-MTRX-230-8X16 BINARY - HDMI 8X16 MATRIX SWITCH WITH HDMI AND HDBASET OUTPUTS - Manual (Page 20)

B-500-MTRX-230 Installation Manual
Pg. 20
© 2013 Binary ™
8.4.2. How to Set Embedded EDID for a Single Input
8.5.1. How to Learn EDID to a Single Input
8.4.3. How to Set Embedded EDID for All Inputs
Example: Input =1 Embedded EDID=4 Display Readout (Example)
1. Press DEFAULT  
2. Press Number Key (1-8) to select one Embedded EDID 04  ..
3. Press INPUT 04  ..
4. Press Number Key/s to select the Input to which the EDID is
applied
04  . 0.
5. Press ENTER
  (success)
FF FF (fail)
Example: Input =1 Embedded EDID=4 Display Readout (Example)
1. Press DEFAULT  
2. Press ALL to select all Inputs  
3. Press Number Key (1-8) to select Embedded EDID 04  ..
4. Press ENTER
  (success)
FF FF (fail)
8.5. EDID Learning
For more advanced EDID configuration, learning can be used to assign EDIDs directly from displays to one or more
inputs. This is useful when the system contains a display that cannot accept the highest resolution available from
sources, but all sources need to be available to all displays.
Note: EDIDs can be learned from displays connected via the HDBaseT or the HDMI output.
When to Use Learned EDIDs
• An older display does not work properly with any of the embedded EDIDs.
• When the source is a PC it may be necessary to use a learned EDID.
• Learning EDID to a single input
Example: Input =1 EDID Learned from Output 4 Display Readout (Example)
1. Press LEARN ONCE to read HDMI port, or TWICE for HDBaseT
port.
L ._. 
2. Press OUTPUT L ._. 
3. Press Number Key/s to select the Output the EDID is learned
from. Use 10+ to select Outputs through 10-16
04  ..
4. Press INPUT 04  ..
5. Press Number Key/s to select the Input the EDID is applied. Use
10+ to select Outputs through 10-16
0 . 4. 0. .
6. Press ENTER
  (success)
FF FF (fail)