Teledyne LeCroy WaveSurfer MXs-B Getting Started Manual - Manual (Page 63)

Getting Started Manual
922172-00 Rev A 55
Edge Mode
This search mode locates all edges in an acquisition and presents them
time-stamped in a table. You can select positive, negative, or both edges.
When the acquisition is stopped, scan filters contained in
Measurements
mode can be applied to the edges to find specific characteristics.
A level marker, corresponding to 50% in this case, is displayed in the source
trace at top.
As with other search modes, a trigger action can be set for Edge mode also.
Non-monotonic Mode
The Non-monotonic search mode looks for edges that cross a threshold
more than once between high and low levels. All events that meet the
criteria of slope, hysteresis, and level are presented in a table and
highlighted in the source trace. The value displayed in the table is the
difference of the max. and min. of the non-monotonicity.
This can be confirmed with cursors: