Teledyne LeCroy X-STREAM OSCILLOSCOPES Remote Control - Manual (Page 137)

Remote Control Commands and Queries
WM-RCM-E Rev D ISSUED: February 2005
131
VALUES FOR RESCALE
FUNCTION:
<addend> : = 0.0 to 1e15
<multiplier> : = 0.0 to 1e15
<units> : = {UNCHANGED, A, CEL, C, HZ, K, N, OHM, PAL, V, W, DB,
DEG
, PCT, RAD, S}
R ESCALE P HYSICAL U NITS V ALUE N OTATION
UNCHANGED
The unit remains unchanged. PAL Pascal
A
Amperes
V
Volt
CEL
Celsius W Watt
C
Coulomb DB decibel
HZ
Hertz
DEG
degree
K
Kelvin PCT percent
N
Newton RAD radian
OHM
Ohm
S
second
AVAILABILITY <sourceN> : = {C3, C4} only on four-channel oscilloscopes.
<extended_source> : = {C3, C4} only on four-channel oscilloscopes
EXAMPLES (GPIB) The following instruction defines Trace F1 to compute the summed
average of Channel 1 over 200 sweeps:
CMD$="F1:DEF
EQN,‘AVG(C1)’,AVGTYPE,SUMMED,SWEEPS,200":
CALL IBWRT(SCOPE%,CMD$)
CALL IBWRT(SCOPE%,CMD$)
The following instruction defines Trace F1 to compute the product of
Channel 1 and Channel 2:
CMD$=“F1:DEF EQN,‘C1*C2’”:
CALL IBWRT(SCOPE%,CMD$)