Teledyne LeCroy X-STREAM OSCILLOSCOPES Remote Control - Manual (Page 216)

P A R T T W O : C O M M A N D S
210
ISSUED: February 2005 WM-RCM-E Rev D
DISPLAY
PERSIST_LAST, PELT
Command/Query
DESCRIPTION The PERSIST_LAST command controls whether or not the last
trace drawn in a persistence data map is shown. This command
checks or unchecks the Show Last Trace checkbox in the
“Persistence” dialog.
The response to the PERSIST_LAST? query indicates whether the
last trace is shown within its persistence data map.
COMMAND SYNTAX
PErsist_LasT <state>
<state> : = {ON, OFF}
QUERY SYNTAX PErsist_LasT?
RESPONSE FORMAT
PErsist_LasT
<state>
EXAMPLE (GPIB) The following instruction ensures the last trace is visible within its
persistence data map:
CMD$=“PELT ON”: CALL IBWRT(SCOPE%,CMD$)
RELATED COMMANDS PERSIST, PERSIST_COLOR, PERSIST_SAT,
PERSIST_SETUP