Teledyne LeCroy BTTracer_Trainer - BTTracer Users Manual - Manual (Page 90)

80
BTTracer Protocol Analyzer User’s Manual CATC SW Version 2.20
will be greyed out unless you have a second BTTracer probe installed in the
right UPAS slot and the system is set to BT1.1 mode.
Channel 1 and Channel 2
Each Channel represents a BTTracer probe. The checkboxes enable/disable
the piconet options listed below them. For UPASs with only the left side
BTTracer probe, the Channel 2 options will be greyed out and the checkbox
for Channel 1 should be checked.
If you have two probes, the second channel is going to be available for
selection.
When using BT 1.2 configuration with two probes present, Channel 1 is set
to follow the AFH while Channel 2 is set to track the basic hopping. To set
the analyzer to BT 1.2 configuration, select Setup > System Configuration
> BT004MA/BT005MA BT1.2 (BTTracer Only).
Assignment
This setting tells the analyzer which piconet to record. With a two probe
system, you can record traffic from two different piconets (Piconet "A" and
Piconet "B") or traffic from a single piconet (Piconet "A") with different
hopping sequences.