Teledyne LeCroy Merlin - Users Manual - Manual (Page 17)

9
Merlin Protocol Analyzer User’s Manual CATC SW Version 2.0
2. Installation
The Merlin Protocol Analyzer components and software are easily installed
and quickly ready to run on most Windows-based personal computer
systems. You can begin making Bluetooth recordings after following these
initial steps.
2.1 System Components/Packing List
• One stand-alone Merlin Analyzer
• One Antenna
• One External Interface Breakout Board with a 9-pin ribbon cable
• One USB cable
• One RF wired Piconet cable
• One SMA Adapter cable (for changing the polarity from reversed to
standard. This cable is used for creating wired piconets.)
• Merlin software program installation CD
• Product documentation
2.2 Analyzer LED and Control Descriptions
The Merlin Analyzer has several user-accessible controls and LEDs.
Figure 1: Front Panel
• Red PWR (power) indicator LED (lights when the unit power is
switched on).
• Green REC (recording) LED (lights when the unit is recording).
• Yellow TRG (triggered) LED (lights when the unit triggers an event).
Note TRG also lights during power-on testing and will be turned off at the end of the
power on cycle. If the LED blinks at the end of this cycle, the hardware is faulty.