Teledyne LeCroy Merlin - Users Manual - Manual (Page 88)

80
Merlin Protocol Analyzer User’s Manual CATC SW Version 2.0
Inquiry Timeout (0-80 secs)
Default value is 20 seconds.
This value specifies how long Merlin should perform the Inquiry process for
the General (unlimited) and Dedicated (limited) recording modes. After the
specified time has elapsed, Merlin will illuminate the trigger light on the
front of the analyzer.
Loss of Sync Timeout (1-30 secs)
This value specifies the amount of time that Merlin will wait for piconet
traffic before determining that synchronization has been lost.
Sync Window
The Sync Window slide bar controls the amount
of time that Merlin should wait between
receiving an Inquiry Response (which will cause
the Sync LED to blink) and detecting Master-Slave piconet traffic (which
will cause the Sync LED to turn solid.)
A "Narrow" setting means that the wait time will be minimal, a "Wide"
setting means it will be "maximal." The default is "Narrow" and this is
suitable for most recordings. However, if significant drift occurs between
Merlin’s clock and that of the Master, Merlin may not be able to sync
properly to the piconet. Under these conditions, you should move the slide
bar towards the "Wide" Setting. The slide bar has five discrete settings.
After sync is established, Merlin will remain in sync as long as there is
piconet traffic.
Debug
Enable CATC debug file
Checking this box enables the creation of a file that can be used by CATC
Support to aid in debugging. This option should always be disabled unless
you are requested to enable it by CATC personnel.
6.5 Recording Options - Inquiry
The Inquiry page configures how Merlin should perform an inquiry. Two
main options are presented in the radio buttons: General (Unlimited) Inquiry
and Dedicated (Limited) Inquiry. These options tell Merlin what kind of
Inquiry it should do. This mode records the inquiry responses from devices.
This page includes settings only for Inquiry recording and BT
Neighborhood.