Iut:hci mode, 2 opening the recording options dialog box, Opening the recording options dialog box – Teledyne LeCroy Merlin - Users Manual User Manual
Page 78
70
Merlin Protocol Analyzer User’s Manual
CATC
SW Version 2.0
'inquiry' page of the Recording Options. The recorded traffic would consist
the transmitted packets as well as the responses received from Bluetooth
devices in the area.
IUT:HCI mode
Configures the system to exclusively record HCI traffic from IUTs. This
recording mode bypasses the analyzer: HCI traffic from the IUT is recorded
directly by the analyzer software without going through the analyzer. This
means that you can record HCI traffic even if the analyzer is not turned on.
To record HCI traffic, first enable the recording of HCI traffic from IUTs.
You do this in the HCI page of the Recording Options dialog. Then set the
recording mode to something other than IUT:HCI. If you want to prevent
the recording of HCI traffic from IUTs, disable it in the HCI page of the
Recording Options dialog.
6.2 Opening the Recording Options Dialog Box
To open the Recording Options menu, click
on the Tool Bar or select
Recording Options under Setup on the Menu Bar.