Teledyne LeCroy TA700_800_850 User Manual - Manual (Page 222)

Catalyst Enterprises Inc. Examples
208
“nFieldIndex” is used to select which field to modify. See the following table for the valid parameters:
for(int nCount = 0;nCount < 8;nCount++)
{
Project->SetEventField(nCount, EVN_NAME ,_T("Add32"));
Project->SetEventField(nCount, EVN_XFER ,XFER_A32);
Project->SetEventField(nCount, EVN_ADD ,_T("00001"));
Project->SetEventField(nCount, EVN_PAR,_T("1"));
Project->SetEventField(nCount, EVN_CBE,_T("0001"));
Project->SetEventField(nCount, EVN_IDSEL ,_T("1"));
EV6 EVN_EV6
EV7 EVN_EV7
EV8 EVN_EV8
FIELD NAME nFieldIndex
Name EVN_NAME
XFER EVN_XFER
AD[] EVN_ADD
PAR EVN_PAR
CBE[] EVN_CBE
IDSEL EVN_IDSEL
FRAME# EVN_FRAME
IRDY# EVN_IRDY
DEVSEL# EVN_DEVSEL
TRDY# EVN_TRDY
STOP# EVN_STOP
LOCK# EVN_LOCK
R/G EVN_R/G
INTX EVN_INTX
ERR EVN_ERR
RST# EVN_RST
PME# EVN_PME
EVENT NAME nEventNo