NEWPORT iDRA Controller - Manual (Page 37)

33
ENTER OUTPUT 1 MENU:
Press a 1) Press a, if necessary, until CNFG prompt appears.
Press d 2) Display advances to INPT Input Menu.
Press a 3) Press a, if necessary, until Display advances to OUT1 Output
1 Menu.
Press d 4) Display advances to SELF Self Submenu.
SELF SUBMENU:
The Self Option allows the output of the instrument to be controlled manually
from the front panel.
Press d 5) Display flashes the current setting of Self, ENBL Enabled or
DSBL Disabled.
Press b 6) Press the b button to select between Enable and Disable.
Press d 7) If Self ENBL Enabled was selected, display shows STRD
stored message momentarily and then advances to the next
menu (Output 1 setting is completed).
The output is now under the direct control of the operator and
can be adjusted in the Run Mode (
M00.0 to M99.9), by
pressing the b and c buttons, where M calls for the Manual
(Self) Control. For example, setting of M50.0 of an Output make
it ON 50% of the time.
8) If Self DSBL Disabled was selected, display shows STRD
stored message momentarily and then advances to oPLO
Minimum/Percent Low Submenu of Output 1 Menu.
There is a shorter way to Enable or Disable Self Mode. From a Run
Mode, press
d and then press a. Self Mode is Enabled now. Press b or
c to display MXX.X. To disable Self, press d and then press a. Display
goes to the Run Mode. Self Mode is Disabled now.
MINIMUM/PERCENT LOW SUBMENU:
Specify in percent, the minimum value (0000) for control output. If the output is
time proportional (Relay, SSR or Pulse), then the minimum duty-cycle, in
percent, is specified.
Press d 9) Display flashes 1st digit of previous “Percent Low” setting.
Press b & c 10) Use b and c buttons to enter a new value for “Percent Low”.
Press d 11) Display shows STRD stored message momentarily and then
advances to oPHI Maximum/Percent High Submenu.