NEWPORT iDRA Controller - Manual (Page 53)

49
DATA FORMAT SUBMENU:
Preformatted data can be sent automatically or upon request from the controller.
Use the Data Format Submenus to determine what data will be sent in this
preformatted data string. Refer to the iSeries Communications Manual for more
information about the data format. At least one of the following suboptions must
be enabled and hence output data to the Serial Bus.
This menu is applicable for Continuous Mode of RS-232 communication.
Press d 37) Display advances to STAT Alarm Status Submenu.
ALARM STATUS SUBMENU:
Includes Alarm Status bytes in the data string.
Press d 38) Display flashes previous selection for “Status” (alarm status).
Press b 39) Scroll through the available selections: NO, YES.
Press d 40) Display shows STRD stored message momentarily and then
advances to RDNG only, if it was changed, otherwise press a to
advance to RDNG Reading Submenu.
MAIN READING SUBMENU:
Includes Main Reading in the data string.
Press d 41) Display flashes previous selection for “Reading”.
Press b 42) Scroll through the available selections: NO, YES.
Press d 43) Display shows STRD stored message momentarily and then
advances to PEAK only, if it was changed, otherwise press a to
advance to PEAK Peak Submenu.
PEAK VALUE SUBMENU:
Includes Peak Value in the data string.
Press d 44) Display flashes previous selection for PEAK Submenu.
Press b 45) Scroll through the available selections: NO, YES.
Press d 46) Display shows STRD stored message momentarily and then
advances to VALY only, it was changed, otherwise press a to
advance to VALY Valley Submenu.
VALLEY VALUE SUBMENU:
Includes Valley Value in the data string.
Press d 47) Display flashes previous selection for “Valley”.
Press b 48) Scroll through the available selections: NO, YES.
Press d 49) Display shows STRD stored message momentarily and then
advances to UNIT only, if it was changed, otherwise press a to
advance to UNIT Temperature Unit Submenu.