WolfVision SCB-1 - Manual (Page 9)

Functions SCB-1
R 7
White balance adjustment errors
If the white balance adjustment is not successful, an error message appears on the screen. If
this happens, take the necessary measures.
Error message Description and remedy
White: Too Bright! The video signal level is too high. Take one or more of the following
measures and then perform the OWB again:
• Remove any brightly illuminated objects
• Decrease the illumination
• Close the iris opening
• Decrease the video gain
White: Too Dark! The video signal level is too low. Take one or more of the following
measures and then perform the OWB again:
• Increase the illumination
• Widen the iris opening
• Increase the video gain
White: Out of Range! Place a white sheet of paper and perform the OWB again.
5.5 User-OSD (On Screen Display)
Beside the on-screen-menu and other camera-messages the SCB-1 also allows the user to
display his own messages. If the User-OSD is enabled, the SCB-1 displays no own messages,
the menu is not selectable.
The camera can display 15 lines of up to 30 characters. The top line can be displayed in the
double character height.
Following colors can be set: black, red, green, yellow, blue, purple, cyan and white.
The color can be set for each line.
5.6 Image Memory
The SCB-1 has an image memory from which a stored image can be output as a still image.
You can store four images plus one frozen image in the memory.
Press one of the MEMORY-keys (1 - 4) for 2 seconds to store a image into memory. To recall
press the MEMORY-key quickly.
To capture the image into memory, use the FREEZE-key. The captured image is output.
5.7 Preset Function
The SCB-1 offer the possibility of programming 9 presets plus 1 power-on preset for the
functions Zoom, Focus, Iris, Positive/Negative and Black/White.
Preset 1 to 4 can be stored and recalled be the 4 PRESET-keys on the SCB-1 Interface board.
Press one of the PRESET-keys (1 - 4) for 2 seconds to store preset into memory. To recall
press the PRESET-key quickly. The presets 5 to 9 can only be controlled via SCOTI (RS-
232).
You can store the current setting as power-on-preset by selecting "Store Power-On-Preset" in
the menu. This preset is recalled when the camera is switched on.