ZOLL M Series Defibrillator Rev D ETCO2 - Manual (Page 16)

M S
ERIES
O
PERATOR
’
S
G
UIDE
- O
PTION
I
NSERT
EtCO
2
- 14
approximately one minute while the module warms to
operating temperature (unit displays “WARM UP”
message).
4. Perform a zero procedure if necessary (see "Zeroing
the LoFlo CO2 Module" on page 8).
5. Breath normally into the adapter.
6. Verify that the unit displays EtCO
2
readings in the
EtCO
2
display area of the monitor.
7. Verify the capnogram waveform is displayed by
pressing the Wave2 softkey.