Extron Electronics SW HDMI Series User Guide - Manual (Page 10)

SW HDMI Series • Introduction 44
Installation
This section describes the installation and setup of the SW HDMI Series switchers. Topics
include:
• Installation Overview
• Rear Panel Features
• Wiring the Power Connector (Optional)
• Wiring for RS-232 Control
• Connecting to the USB Port
• Enabling Auto-input Switching
Installation Overview
To install and set up the SW HDMI switcher:
1. Turn off all equipment and disconnect it from the power source.
2. (Optional) Mount the switcher on a rack shelf or furniture (see “ Mounting the
SW HDMI ” on page 31).
3. Connect HDMI input sources to one or more of the SW HDMI input connectors.
4. Connect an HDMI output device to the output connector.
5. Connect control devices. Connect your computer to one of the following SW HDMI
ports to configure and control the switcher via SIS commands or the Universal
Switcher Control Program:
• RS-232 port — Pins 1, 2, and 3 of the Remote port (
d
on the rear panel
diagrams on the next page) for serial RS-232 control. (See “ Wiring for RS-232
Control ” on page 7 for connection procedures.)
• Config port — USB mini B connector (
f
on the front panel diagrams
on page 11) for USB control. (See “ Connecting to the USB Port ” on
page 8 for connection procedures.)
6. (Optional) Enable auto-input switching. Use a jumper to connect pins 4 and 5 of
the 5-pole captive screw plug that you plugged into the Remote connector in step 4
(see “
Enabling Auto-input Switching ” on page 10).
7. Power on the output display.
8. Connect power to the switcher (see “ Powering On the Switcher ” on page 13).
9. Power on the source devices.