Extron Electronics SW HDMI Series User Guide - Manual (Page 20)

SW HDMI Series • Operation 14
Using the Optional IR 102 Remote Control
The optional hand-held IR 102 Remote Control (part number 70-224-10) lets you
remotely perform functions that are also available through the front panel buttons and SIS
commands.
The IR receiver port on the front panel is located to the right of the Auto Switch LED. It
receives signals from the remote control if they are sent from within a 40-degree arc to the
right or left of direct line of sight between the remote control and the switcher receiver,
and from no more than 30 feet (9 m) away (see figure 12).
SW HDMI Series Switcher
IR 102 Remote Control
SW4 HDMI
HDMI SWITCHER
1
IR
CONFIG
SIGNAL
INPUTS INPUTS OUTPUT
1 2 3 4
HDCP
2 3 4
AUTO
SWITCH
40 40
30’
Maximum
Channel
IR 102
0
1 2 3 4
5 6 7 8
9 +10
Universal Remote
Figure 12. Area for Remote Signal Reception
Remote control buttons
On the IR 102 remote control, buttons 1 and 2 or
1 through 4 (depending on your model) select inputs.
Button 0 mutes (deselects) all inputs.
a
Input Selection buttons — Press one of these
buttons to select an input.
b
Input mute button (0) — Press this button to
deselect all inputs, effectively muting the output.
Locking IR remote access
The SW HDMI can be set to lock out users from using the
IR 102 Remote Control to control the switcher. Remote
access can be enabled and disabled via SIS commands
(see the
Front Panel IR Receiver Enable and Disable
commands on page 23 in the Command and Response
Table for SIS Commands). When remote access is set to Off, all switcher controls remain
available through the SW HDMI front panel.
Universal Remote
INPUT/OUTPUT SELECTION
1 2 3 4
5 6 7 8
9 0 +10
IR 102
1
2