Extron Electronics SW HDMI Series User Guide - Manual (Page 33)

SW HDMI Series • Remote Communication and Control 27
On the Add Device window, the path to the new firmware file is displayed in the Path
field.
Figure 19. Path to the New Firmware File on the Add Device Window
10. If this is the only device to which you are uploading firmware, click Add . The
switcher information is added to the Devices section of the Firmware Loader window
and the Add Device window closes.
If you will be uploading the firmware to multiple SW HDMI switchers that are
connected to your computer, do the following:
a. Click Add Next . Your first device is added to the Devices section of Firmware
Loader window, and the Add Device window remains open.
b. For each additional device you want to add to the Firmware Loader window,
repeat steps 5 through 9, then click
Add Next .
c. For the last device, click Add (instead of Add Next ) to add the device and to close
the Add Device window.
Figure 20. Firmware Loader Screen with an SW HDMI Added