Operations, Powering on the switcher, Selecting an input – Extron Electronics SW HDMI Series User Guide User Manual
Page 19: Resetting
SW HDMI Series • Operation
13
Operations
Powering on the Switcher
To power on the SW HDMI:
1.
Connect all input and output devices to the rear panel connectors on the switcher (see
“
” on page 5 for the rear panel connections).
2.
Power on the display.
3.
Plug the power supply into the 2-pole captive screw power connector on the switcher
rear panel. After approximately 4 seconds, the following takes place:
•
The unit performs a self-test, during which the front panel Auto Switch, Input,
Signal, and HDCP LEDs each blink once in sequence from left to right. When the
self-test completes, the LED for the most recently selected input remains lit.
•
The switcher reads the available EDID information from the connected output
device and writes it to memory on each input. When power is removed, these
settings remain in memory and are in effect when power is reapplied.
NOTE: If EDID Minder is in automatic mode, the settings revert to the default
EDID unless a display is connected to the HDMI output (see “
4.
Power on the input devices.
Selecting an Input
To switch (tie) an input to the output, press the desired input button on the front panel
(ensure that auto-input switching is not enabled). The LED corresponding to the selected
input button lights.
•
The lit front panel input LED indicates the selected input. The LED remains lit until a
new input is selected.
•
Only one input can be switched to the output at a time.
Other ways to select an input include using SIS commands (see the
commands on page 22) or optional IR remote control (see “
Resetting
To reset the switcher to its factory default settings:
1.
Press and hold the Input 1 button while power is being applied to the unit.
2.
Continue holding the Input 1 button until the power-up sequence completes.