Extron Electronics SW HDMI Series User Guide - Manual (Page 15)

SW HDMI Series • Installation 9
• Select the Yes, this time only radio button if you want your computer to
connect to Windows Update only this one time.
• Select Yes, now and every time I connect a device if you want the computer
to automatically connect to Windows Update to search the web every time the
switcher is connected to this USB port.
• Select No, not this time if you do not want the computer to connect to
Windows Update to search the web at this time (for example, if the driver is
already on your computer).
3. Click Next . On the next screen, select the Install the software automatically
(Recommended) radio button, then click Next (you do not need to insert a disc).
Figure 8. Selecting the Radio Button to Install the USB Driver Automatically
Your computer locates the driver needed for it to communicate with the SW HDMI via
the USB port and loads it to the computer hard drive.
4. When the Completed screen appears, click Finish to close the wizard.
NOTE: This wizard appears only the first time you connect the SW HDMI to
each USB port. You do not see the wizard again unless you connect the
switcher to a different USB port on your computer.
5. Configure the switcher as desired using SIS commands (see the Remote
Communication and Control section, beginning on page 19, for information on
available commands).