Rear panel features, Rear panel, Diagrams – Extron Electronics SW HDMI Series User Guide User Manual
Page 11
SW HDMI Series • Installation
5
Rear Panel Features
0.3A MAX
POWER
12V
1
Tx Rx
RS-232 AUTO
2
INPUTS
OUTPUT
REMOTE
0.3A MAX
POWER
12V
2
3
4
1
G
Figure 2.
SW2 HDMI Rear Panel
0.3A MAX
POWER
12V
1
Tx Rx
RS-232 AUTO
2
3
4
INPUTS
OUTPUT
REMOTE
3
2
1
4
G
Figure 3.
SW4 HDMI Rear Panel
a
Power connector — Plug the provided external 12 VDC, 1 A power supply into this
2-pole, 3.5 mm captive screw connector and into an AC power outlet.
b
Video input connectors — Connect HDMI video input sources to these Type A
female single-link HDMI connectors. Data rates of up to 6.75 Gbps are supported.
•
LockIt
®
brackets: LockIt cable lacing brackets, one for each HDMI input and
the output connector, are provided with the SW HDMI. These brackets can be
used to secure the HDMI cables to the rear panel connectors, reducing stress on
the connectors and preventing signal loss due to loose cable connections. For
information on attaching the LockIt brackets, see the LockIt HDMI Lacing Bracket
Installation Guide, available on the Extr
.
•
EDID information: By default, EDID is read from the output device and
written to switcher memory for each input, allowing the source to see the EDID
information for the output device even when the output is switched away from it.
NOTE: If power is recycled to the display, or if a new display is connected, the
source may need to be rebooted to read the new EDID.
c
Video output connector — Connect an HDMI display device to this female Type A
HDMI connector.
The EDID information is read from the connected output device via this connector and
is written to memory on each input whenever the output device is connected this port
and powered on.
NOTE: The EDID information is also read and stored whenever power is recycled
to the connected output device or when the output device is replaced.