Extron Electronics SW HDMI Series User Guide - Manual (Page 39)

SW HDMI Series • Reference Information 33
9.5-inch rack
Use 2 mounting holes on
opposite corners. (2) 4-40 x 3/16"
Screws
1U Universal Rack Shelf
Front false
faceplate
uses 2
screws.
1/2 Rack Width Front False
Faceplate
Figure 23. Mounting an SW HDMI Switcher on a Standard 9.5-inch Deep Rack
Shelf
Back of the rack mounting
The SW HDMI can also be mounted vertically to the front or rear rack supports, using the
optional MBB 100 Back of the Rack Mounting Kit (part number 70-367-01) as follows:
1. If rubber feet were previously attached to the bottom of the unit, remove them.
2. Remove the two screws from each side of the switcher. Retain the screws for possible
later reassembly.
3. Attach the brackets to the sides of the unit, using the longer screws included in the
mounting kit (see figure 24).
Figure 24. Attaching the Back of the Rack Mounting Brackets to an
SW HDMI Switcher