Command and response table for sis commands, Input selection – Extron Electronics SW HDMI Series User Guide User Manual
Page 28
SW HDMI Series • Remote Communication and Control
22
Command
ASCII Command
(Host to Switcher)
Response
(Unit to Switcher) Additional Description
Input Selection
Select input
X!
!
In
X!
• All
]
Select input
X!
.
X!
= input number: 0 through the
highest number of inputs on the switcher
(2 or 4).
0 deselects (mutes) all inputs
Video Muting
Video mute
X@
B
Vmt
X@
]
Mute the video signal.
View video mute status
B
X@
]
Show video muting status
X@
. For
X@
:
1 = muted; 0 = unmuted
Audio Muting
Audio mute
X@
Z
Amt
X@
]
Mute the audio signal.
View audio mute status
Z
X@
]
Show audio muting status
X@
. For
X@
:
1 = muted; 0 = unmuted
Video Color Bit Depth
Set video color bit depth mode
E
V
X#
* BITD
}
Bitd V
X#
]
Select color bit depth mode
X#
. For
X#
:
View audio mute status
Z
X@
]
0 = automatic, based on the EDID of the
connected output.
1 = Force truncation to 8-bit.
Signal Status
Request status of all signals
E
LS
}
Sig
X1)
•
X1)
*
X1)
] or
Sig
X1)
•
X1)
•
X1)
•
X1)
*
X1)
]
Show signal presence or absence for all
inputs and the output. For
X1)
:
0 = no signal detected
1 = signal detected
Request HDCP status
E
HDCP
}
HDCP
X(
]
Show HDCP status
X(
for all inputs.
For
X(
: 0 = HDCP not required;
1 = HDCP required
EDID Minder
Assign EDID to inputs
E
A *
X$
EDID
}
EDID A
X$
]
Select an EDID file for all inputs.
X$
= EDID file location number (see
below):
0 = Automatic mode (default): EDID of
the connected display is detected and
passed to the inputs.
1 – 46 = Factory-supplied EDID (see the
on page 17).
47 – 50 = User-loaded EDID
Example:
E
A * 9 EDID
}
EDID A 09
]
Select EDID file 9 (
1
440 x 900
@ 60 Hz)
to be stored in memory for the inputs.
View EDID assignment
E
A * EDID
}
X$
]
Show the number (
X$
) of the EDID file
currently assigned to the inputs.
View EDID in hex format
E
R * EDID
}
X%
]
View the current EDID assignment in
hexadecimal (256 bytes).
X^
= current EDID information in hex
code.
Command and Response Table for SIS Commands