IEI Integration PICOe-HM650 - Manual (Page 78)

PICOe-HM650 Half-size PCIe CPU Card
Page 64
4.6.2 SATA Drive Connection
The PICOe-HM650 is shipped with two SATA drive cables. To connect the SATA drives to
the connectors, please follow the steps below.
Step 1: Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
Step 2: Insert the cable connector. Insert the cable connector into the on-board SATA
drive connector until it clips into place. See
7
Figure 4-16.
Figure 4-16: SATA Drive Cable Connection
Step 3: Connect the cable to the SATA disk. Connect the connector on the other end
of the cable to the connector at the back of the SATA drive. See
7
Figure 4-17.
Step 4: Connect the SATA power cable. Connect the SATA power connector to the
back of the SATA drive. See
7
Figure 4-17.