IEI Integration IBX-530B-N270 - Manual (Page 32)

IBX-530B-270 Embedded System
Page 20
3.5.1 Access the Jumpers
To access the jumpers, remove the back panel. To remove the back panel, please refer to
Section 4.2.3 .
3.5.2 AT Power Select Jumper Settings
Jumper Label: JP4
Jumper Type:
2-pin header
Jumper Settings: See Table 3-2
Jumper Location: See Figure 3-2
The AT Power Select jumper specifies the systems power mode as AT or ATX. AT Power
Select jumper settings are shown in Table 3-2.
Setting Description
Short Use ATX power Default
Open Use AT power
Table 3-2: AT Power Select Jumper Settings
The location of the AT Power Select jumper is shown in Figure 3-2 below.
Figure 3-2: AT Power Select Jumper Location