IEI Integration IBX-530B-N270 - Manual (Page 52)

IBX-530B-270 Embedded System
Page 40
VGA cable connector
Serial port connectors
RJ-45 connectors
USB devices can be connected to the system.
The cable connection locations are shown in Figure 2-2.
4.3 Power-On Procedure
4.3.1 Installation Checklist
WARNING:
Make sure a power supply with the correct input voltage is being fed into
the system. Incorrect voltages applied to the system may cause damage to
the internal electronic components and may also cause injury to the user.
To power on the embedded system please make sure of the following:
The memory module is installed
The wireless LAN module is installed
The CF module is installed
The bottom cover is installed
All peripheral devices (VGA monitor, serial communications devices etc.) are
connected
The power cables are plugged in
The system is securely mounted
4.3.2 Power-on Procedure
To power-on the IBX-530B-N270 please follow the steps below:
Step 1: Turn on the power switch.
Step 2: Once turned on, the green power LED should be turned on. See Figure 4-12.
Step 0: